Phineas
| Line 53: | Line 53: | ||
===Mechanical=== | ===Mechanical=== | ||
| − | * Flatten the stepper shafts and remount the X & Y pulleys | + | * Flatten the stepper shafts and remount the X & Y pulleys - done |
| − | * Build and install new hotend | + | * Build and install new hotend - done .35 nozzle |
===Software=== | ===Software=== | ||
| − | * | + | * Pronterface |
| + | * [https://picasaweb.google.com/lh/photo/TirTcg47PfZAf2lZk6cUPw?feat=directlink 10/2/2011 CURRENT SCREENSHOT OF SETTINGS] | ||
Revision as of 05:16, 2 October 2011
ACTIVELY BUILDING THIS PAGE FROM A COPY OF THE BREEPBROOP PAGE, WORK IN PROGRESS
Information
Pic goes here
Link to raising geeks goes here
General
Phineas (nickname) is a RepRap Prusa Mendel, built from a MakerGear Prusa Mendel Kit.
It was purchased and built by Ian (Digitalman2112) between April and June of 2011.
Photos
Warning, I make mistakes, and sometimes the mistakes stay in the photos - don't use these as your only reference :)
Build Photos - Heated Build Platform
Documentation
MakerGear Prusa Build Instructions - These are a complement to the Visual Prusa Instructions
Electronics
- RAMPS
- Polulu
- Fan for Polulu
- Power Supply
- ???
Mechanical
No mods, yet. Note that Rick from Makergear prints with his X "backwards", so the X endstop needs to be reworked to be "correct"
Software
Ian (user link) is currently using the following:
- skeinforge link
- firmware TBD
Print Status
The printer is not printing. Ian hasn't been spending the needed time, had a bunch of self-inflicted heater core issues, and just generally hasn't worked through it...
Current Work
Electronics
- Get the fan on the polulus
Mechanical
- Flatten the stepper shafts and remount the X & Y pulleys - done
- Build and install new hotend - done .35 nozzle
Software
- Pronterface
- 10/2/2011 CURRENT SCREENSHOT OF SETTINGS
